Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a discussion with eHealth via partners to view the QoS traffic on the routers. They stated that we should activate the MIB variable on the router. Therefore, can someone tell me if the MIB CISCO-CLASS-BASED-QOS-MIB is supported on all Cisco R...
I have an issue that E-health is only reading the last attempt when ip sla UdpEcho is configured on the router. I don't known if this issue is related on the Cisco router or on the E-health monitoring tool. The configuration on the router is:ip sla m...
When trying to configure to 5th primary, I have the following error message:Router(config)#contr e1 2/4Router-B(config-controller)#pri-group timeslots 1-31%Insufficient resources to create pri-group - it has been removedRouter-B(config-controller)# ...
Thanks for your feedback. There was a small mistake in the configuration of the router concerning QoS which I have overlooked.Thanks for your assistance it is working fine now.
The mib locater indicates that the mib tree exists on the router but a snmpwalk give no result:Met OID .1.3.6.1.4.1.9.9.166bash-2.05$bash-2.05$ ./GetTable2.plNo results found for 164.140.221.11 with ***bash-2.05$output of show version:Cisco IOS Softw...
The idea behind this question is that currently E-health is configuring the router with SNMP RW password to collect the data. Because we don't want the send the password over the wire, we would like to configure the router itself to do the measuremen...
