Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently setup a VPN to a remote site and that remote site has multiple subnets. The VPN is up and running and subnets can access main site and its resources fine through VPN except internet. Meaning I am unable to access the internet from any of t...
I used the Cisco Wizard to create a site-to-site VPN and having trouble with devices on either side communicating. The VPN is up and the ASA5505 at the remote site is able to ping the outside interface of my data center's ASA. The ASDM syslog messag...
I have a fax at a remote site on a POTS (B-1) line. I have a 2911 onsite with FXO/FXS ports. I would like to route the incoming faxes into my CallManager in order to distribute to another site's fax machine. I currently have the fax/POTS line plugged...
CUCM version 10.5.x
How do I disable Cisco announcements, "Wait while I transfer your call" and "Thank you for calling"? I have found reference to this issue in this forum and Google'd but without any real solution or even Cisco documentation referen...
Hi Rob! Sorry for the delayed response - I went away for Memorial weekend and am just now getting back to this. It must have been a DNS issue because your suggested config additions posted on the 25th resolved the issue with accessing the internet fr...
10.10.1.0 and 10.20.1.0 are subnets on data center side and I was not sure if you wanted me to run the NAT statements for these subnets on the remote ASA5505 or change them to 10.10.5.0 and 10.20.5.0 so I ran both and posted results separately in att...
Hi Rob, Thanks for response and pointing me in the right direction. I'm now able to access the internet from from the 10.0.5.x subnet but not the others (10.10.x.x, 10.20.x.x, 10.30.x.x, etc.). I've attached my updated config.
Thank you so much for your time and response, Rob! It was a routing issue (per your last post) with static routes on 5505 (remote ASA) pointing to the wrong IPs. The additional subnets should have been pointed to the switch IP (see below). On the si...
