Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi thereI have an access point AIR-LAP1242AG-A-K9 running IOS C1240 Software (C1240-K9W7-M), Version 12.4(3g)JA.Firstly, I can see the access point in my cdp neigh table on my switch to which the AP is connected to but I cannot ping the IP address o...
I have upgraded our WLC 4402 to software version 7.0.116.0 and then about an hour later my core switch rebooted and then came back online. About 15 minutes later it rebooted and never came back up. The switch need to be rebooted and and after that al...
I have applied the kron command:kron occurrence Save at 23:00 28 recurring with the policy list, etc.My NTP is working. The kron script ran the fist time through and then the second time, it did not run on the specified day which is the 28.The kron s...
I have attached the crash info.The switch was power recycled becasue we could not get to the switch. Thats why under the sh ver it shows System returned to ROM by power-on.Let me know your thoughts.
I have attached the sh ver for this switch.How would I display the crashinfo?There is a crashinfo dir under the flash and there are 2 crashinfo files. I tried to tftp the file but was unsuccessful.Any other suggestions?
Thanks for your reply.Ok when enabling P2P Blocking action to "Drop", that would prevent users from seeing each other on a public network. Is this correct?So my question would be then if P2P Blocking action "Drop" prevents users from seeing each othe...
I have attached the show stack from the router that crashed and recovered.This is the sh ver from the the router that crashed and needed to be reloaded...Cisco IOS Software, 3800 Software (C3845-ADVIPSERVICESK9-M), Version 12.4(16), RELEASE SOFTWARE ...
