Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello folks, In order to upgrade to UCS Central 1.1 there is a requirement to increase the disk1 size to 40 GB from 20 GB as was needed before. Now when I try to use Gparted it doesnt recognize the partition (lists as unknown format )and therefore d...
Hello, I have a Cisco Pix in my test lab and someone has put some 3000 access-list remark lines on it and I'm having a hard time removing those. I've tried tftp new config after deleting those lines on notepad, didnt work. I tried to simply delete t...
I'm doing some testing here and am facing a issue with the 8.0 OS. when I'm logged in via the management interface and try to re-IP the same interface (with the same IP of course) the ASA disconnects. Is that a known behaviour of the ASA and if it is...
Is there any way to control the prompt on AIM cards? I have a command reference for 3.0 and above, but the normal config commands like "prompt ..." don't exist. The problem this device presents is that it does not output a clean text-based prompt, su...
I am trying to set up a test environment where I need to be able to be asked for both a username and password while entering enable mode from exec mode on a cisco IOS router. I was told the only way to do that is through Tacacs. But I've not seen any...
I had done that before but it wasnt working. Okay..I tried it again and still no luck. It doesnt prompt me for username againon entering enable mode.AUTHENTICATION REQUIREDUsername: uzmaPassword:=======================================================...
Okay..now I've gotten it to where its asking me for username password for exec level..but it still only asks me enable password..still doesnt ask me for username when I try to get into enable mode...Is there any group setting I need change in order t...
