Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all. First post, so I apologize if I don't lay things out clearly, or if this is the wrong forum.
We are a small/regional ISP. We have a customer who has a couple of /24s (not purchased through us), and they would like us to announce these /24...
We are having trouble connecting a 7206 to a Cerent 454 over mutlimode fibe between WS-5484 SX GBIC's on the devices.The sh int g0/3 on the 7206 shows line up and protocol down. Sh contr 0/3 shows the link down with no carrier. Even with the fiber pu...
I have a question, looking for some insight into our issue. Our DSL network is a flat layer 2 networks with approx. 1800 subscribers attached. Becasue of this, the core router, a 3745, has 28 secondary IP addresses attached to its internal interface....
I am looking for a router to replace a redundant set of 3550-48's. I need the switches where I can utilize the port density, and only really need a few ports and VLANs to be routed. The traffic maxes out at about 20Mb, with growth to not exceed 40MB ...
Hey Jason. Thanks for the response.
We've passed the LOA upstream, but I think they are not sure how to process it either. Our upstream is currently going through a bankruptcy/acquisition, so things are a big chaotic. We're redundant to them, but wo...
Hello,We are trying to NAT a multicast group through an ASA 5510 running 8.2.1. We have it in routed mode and the group 224.1.1.8 exists on the inside, and we want it to be 227.1.1.10 on the outside. We can NAT the source, but need the group to be tr...
