Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a number of Barcode printers. The can connect to an AP when configured directly as the Dotradio interface and a single ssid, but can not connect to the same AP when dotRadio subinterfaces are used, and there are multiple SSIDs on the AP....
Thanks Jim, I've tried this but it still just wipes the config. It keeps the basics like name, but the switchport config is lost.I've tested by taking a sample switch that is currently unused but connected to the LAN, putting on some config (vlans,...
Hi, I've a similar problem. Its an existing network that has been up and running for a while. There are a number of devices that need shifting for new networks to provide logical and admin separation.I dont think templates will help in this case? ...
Hi, Its interesting that the HSRP are reporting active/active. If HSRP is configured correctly, this means the link between the vlans is incorrect in some way. I'd check the cabling physically between the switches, then compare the trunk interfaces...
I was in Kinston last week setting up routers at several sites. We initially found the same issue.Kingston/Hull is an odd area all unto itself.Change the PCV to 1/50 :establish a PPP session in accordance with RFC 1661 [15].support PPPoA or PPPoE as ...
Thanks George, Leo and David.After much config changes and trying every combination i could think of. I went back to the printers. The ones giving me the problems are B only machines. The firmware upgrade on these machines was through the printer v...
