Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two Cisco 5585 in a cluster. My understanding of the "show cluster access-list" command is that it shows the hit count as (x+y, x, y), with the first value as the aggregated hit count of the other cluster members. So if I have to cluster membe...
I'm looking at the At-A-Glance sheet for the Cisco 3650 switches. It says for the WS-C3650-24PD you can have "2 x 10 Gigabit Ethernet with SFP+ (or 4 x Gigabit Ethernet with SFP)"
It says for the WS-C3650-24PD you can have "2 x 10 Gigabit Ethernet wi...
I am implementing GET VPN. I have set my KSs to receive-only mode, so all my GMs are in inbound-only mode. I did this because I want to see if there are problems with registration, I expect that if there are problems it will not affect production tra...
This is a bit long, so bear with me. I have a strange issue, which I can't say if it is causing any problems. I've configured a hierarchical QoS policy on the hub router of our network. It has a WAN speed of 20Mbps, while the DR site has a speed of 1...
I'm implementing QoS and encountered a problem where the router is not recognizing the DSCP information from the LAN.On the LAN Switch port connected to the router I have:!interface GigabitEthernet0/1 switchport trunk encapsulation dot1q switchport m...
You need to copy the OVA file to the bootflash or the harddisk in order to use the setup. It doesn't appear that you have the file uploaded onto the router.
Thanks for the info.
I found out the 3650 SFP+ models will support either 10 or 1 Gig, but you can't mix them. So you can't have one port at 10G and the other at 1G.
Some of the 3850 models can do that though.
Sachin
Sorry I took so long to answer this.
The SA Receive_Only allows traffic to be received either in encrypted or in plain text. It is used when rolling out GET VPN when all the routers have not been converted to group members. So you have misunderstood ...
I can't find anything wrong with your config.Are you network devices configured to use the internal interface of the firewall as the default gateway? Or do you have a route to 10.171.81.0/24 via 10.171.80.1?
