Hello!Currently I have a 2621 with a 8 port anlog modem module. I can only get the modems to connect at 21600bps. It is using V.34, so I assume it should connect at 33600bps. Any idea how I can't get the speed on the connection up to 31000 to 33600 ?...
we are trying to get a 1721 router with ip ver12.2(8)T to share ntp with a cat 4006 L3 module. The L3 module points to a ntp master outside our network and works fine. I do a debug sntp packets on the 1721 and see sends and recieve packets from the L...
How do you increase the amount of memory for I/O in the Cat 4006 L3 module. currently the memory is fixed, you can't add any at the hardware level. I would like to adjust the memory, and add more to the I/O.
Hi George.In short a channelized T1, is one that has been broken into 24 time slots (channels). You could use 12 channels for voice and 11 for data. If the circuit is unchannelized, you will not have this option since the circuit is one whole unit.
Hi RajIf you want to assign static ip's to each, you could just take off the dhcp and tell the users to hardcode an ip into the dialup connection. You could also use DHCP from a Win2k box. Configure the DHCP server to assign ip's based on user MAC ad...
Thanks for the feed back. You where dead on in both cases, the modem set was incorrect. I changed it back to modem auto discover and now works. Some times I can can connect at 31kbs and other times it connects at 28.8kps. That is with the modem in m...
Hi Vincent !!I posted a porblem that is occuring with a 3620 router with 8AM modems. I can't get the speed past 21.6kbps, yet I have a shiva modem with the same line that I can connect at 26.6kbps. Take a look at the post I left on Jan 6, if you have...
Hello again!Try just using pap on your Async Interface, if you get it working then enable chap and disable pap. Questions:1) do you need to directly loding to the async interfaces or just pass user through? if you only need users to login into radius...