Dear netprosi need help with MRTG drawingi have an AS5300 with 4E1 and i need OID for ASR,call attempts,active calls,failed callson each E1 in order to set he MRTGtks
Dear netprosanyway to access the router through aux port?my problem is : when i tried to access the router through the console ,i cant type any character and as the router is empty , telnet wont be a solutionplease helptks
Dear Netprosi have call that hang on my 5300 ver Version 12.3(10a)any way for me to disconnect that specific call manualy without disconnecting other active calls?tks
Dear alli am getting this disconnect cause "DisconnectCause A , DisconnectText n/a" on my AS5300 ver 12.3(9a)i search everywhere to know what it means with no luckplease helptks
Hithere several solution for your problem, but i suggest the easiest one which is as following:configure each cisco switch at each site in a way that all existing computers that have access to the internet will be plugged to specific port and shut do...
Hiwell you will definitly notice a difference in quality using G711 but the only issue is you need higher bandwidth as G711 need around 64k for each callFadi
tks for replysorry but it didnt workmy controller config is :controller E1 0 clock source line primary ds0-group 0 timeslots 1-15,17-31 type r2-digitali have this call hanged and i want to clear only this one:34B2 : 272589040ms.1 +25970 pid:78871 Ori...
