Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I need to upgrade the CIMC for a PI-UCS-APL-K9 but i don´t found the drivers or utility for this. I woud lie to know if i can upgrade this with the huu utility for ucs 220m4, or what could be the correct way to do that. Thank you
A customer is performing the ipv6 implementation. the wlc is currently being configured, the ipv6 address was set in the management interface, this ip responds ping from the core, but from another vlan in the network does not respond ping. I would li...
I have a client that has two wlc 2504. The configuration was made to be in HA SKU N + 1. At the moment of connecting both in the network it is observed that the mobility group looks good and both wlc are seen. But at the time of restarting the primar...
The client has installed the ise nodes with VM similar to the 3595 appliance. Due to an inconvenience that arose, it was necessary to review a support bundle and there were some CPU alerts, due to this the recommendation to enable hyperthreading to a...
The integration of ISE with Aruba is being carried out.
ISE is in version 2.2 and is being integrated with an IAP that is in 8.5
The configuration was done by guiding us with the following document, where each step is explained well.https://www.cisco...
Yes, the revision of the guide has been done but we have the doubt of the dual stack configuration in the case of APs On the other hand, APs do not use flexconnect, as I see in that case the recommendation is to enable multicast for ipv6, is that cor...
Hello, The configuration over each AP was made before we maked the test. But even configuring both wlc over APs (one primary and other secondary), the APs never associate with one WLC
Hello,According to the configuration recommended in the guide, this should work. Some changes have been made but it's still the same error
May it have to see with the model and the firmware version of the Aruba IAP?
For this type of integration, i co...
Hello, The test was performed in another virtual machine to verify that effectively with the upgrade of the hd of the vm, the operating system could be modified to red hat 7. I have two questions: 1. At the moment of doing the hd upgrade of vm, a mes...
