Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
all:i have an access point that sits 75 ft away from a wgb. the problem is the wall between them... i can't seem to get a signal to the wgb through the wall. if i move from behind the wall i can get access... is the ANYTHING i can do to penetrate the...
Has anyone had an issue with the AP Radio (on a AP-340) going up and down? Also, it only happens when I add another 350 WGB to the network - it doesn't happen right away but rather an hour or two later... weird... once it, the radio, starts bouncing...
does anyone know why when I enter a command into my router it does not register in the router config? i do the following command - and then when i do a "show run" it does not appear.config trouter ospf 1111network 10.117.254.84 0.0.0.3 area 55
All - I currently have a 350 WGB and need to order another one. However, I was told these are now EOL. What can I order in it's place? What I need to do is get wireless from one area to another and then connect an 8-port switch to that wireless devic...
All - I currently have a 350 WGB and need to order another one. However, I was told these are now EOL. What can I order in it's place?What I need to do is get wireless from one area to another and then connect an 8-port switch to that wireless devic...
i've checked all the cabling and it's correct. the original error I received was the following. This was on my 4506%EC-5-DONTBNDL: Gi1/2 suspended: incompatible partner port with GigabitEthernet1/1On my 4503 I received the following:05:46:54: %EC-5-D...
so, i've narrowed it down. the 4507 appears to be fine - i've tested it going to another 4506. the problem seems to be on the 4506. for some reason it show's every interface (including the VLANS) as DOWN - DOWN;whereas every other switch is UP - DOW...
