I've been looking on cisco's web site looking for cisco ios's for ---(cisco 7500, 6500, 3640 and 3745) and I can't find any yet. Can you guys recommend something for these four routers....The 6500 has a rsm.
We have converted a cat 6500 os to a native os(what a task). My question to the group is ....Is the switchport command capable of joing multiple gigabit ports to a vlan? If so what are the commands? I've tried to use the typical switchport mode acces...
I have a 3924 that I accidentally deleted the flash on it. Since then I've tried to reinstall the ios on it and I keep getting a permission issue. I have attached the error messages down below. I just would like to know how to load my ios back on my ...
thank youI did find out how to do this. Your answer was very beneficial and you are correct to know that the range command is a little quirky...I put in the commands plenty of tries and couldn't get them to work but this afternoon I was able to make ...
thank you very much...I think that I messed up with the vlan part...I created a vlan on vlan 1 and did the ip routing and went to the fast ethernet port to give it an ip address in order to connect to the tftp server. I didn't know that I was suppose...
i tried to put the emi image on a 3550 switch but I couldn't get it to ping my workstation...can you send me your config...I have a vlan setup with a basic ip address and then I have the port set up withe the address in the same network range as the ...
ahoejmark.....question for you? Where can I find more information on the catalyst 3550 w/emi code. I just bought one and would like to find more information on them. So you're not quite for sure if GLBP is supported on the 3550 w/emi?