Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,I have 5 ISE 2.6 patch 6.1 PRI(A),SEC(MNT)1 SEC(A),PRI(A)3 PSNIn the PAN license menu, it was showed the wrong base license count. I use bellow procedure:application configured ise Reset M&T Session Databaseon both PRI(MNT) and SEC(MNT)and i...
Hi,I configured my hub and spoke router with dVTI and policy base ip address assing to spoke router.Everything works fine but the IP address of speaking router tunnel don't show in routing table static and i cannot ping the tunnel ip address and then...
Dears, I deployed distributed ise nodes with five nodes.The two nodes are pan and three nodes are psn.but now I have two primary active pan and I can`t remove any of them. May you please help me to remove one of them or change it to secondary pan.
Hello
while SM-2GE-SFP-CU has two Gigabit port , i can';t see more than 160Mbps downstream throughput from one of the ports , and in data sheet it said throughput of the SM module is 100Mbps bidirecttional , if this is true why it has two Gigabit po...
Dear,Thanks for your help.How can I find why the ISE base license consume.I have the same problem. I try to use profiling and after that my base license increase daily.The Ise showed license maximum 1600 per day. but after it it grows to 2500 and aft...
thank you Leo, i got my answer
but router that SM module is on that, is 3925 with SPE100 , customer can get real 1Gbps from backplane GE ports of the router , while on SM module throughput is much lower
what i want to know personally is this, you tol...
as i forwarded my colleague discussion, i guess he mean aggreate throughut of two ports on the SM card , or maybe 40Mbps send and 100 Mbps receive , not possible?
in the meantime, main question is this: customer must not expect 1Gbps throughput on Gi...
