Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
I have been working on a couple 4402 units that I purchased used. Seller said they had loaded firmware and power tested to boot. I purchased 2 units and both of them get stuck after the boot options prompt in CLI. Both units will not ...
I am having some issues with my configuration to where it will not allow my to ping past my Hwic card (ATM 0/0/0). Any help would be greatly appreciated. My show run is attached.
Thanks,
Allen
Router#show run
Building configuration...
Current...
Well here is my update.I received my proper adapter for my console cable and the system is working as it should. Apparently the one that I had made was making the bootloader freeze by thinking I was pressing keys. So far I have gone through the con...
I just tried it with the settings that you requested and it most of the time will not boot all the way through. However 1 time while I was pressing the "ESC" key and "Enter" key in an alternating pattern I noticed that the status light was flashing ...
Unfortunately it won't accept the "ESC" command. It just waits about 30 seconds probably and then goes to the "detecting hardware" prompt.
Could it be how I'm connected to the console? I bought a RJ45 to DB9 adapter but it was the wrong pin out...
I tried to make all the changes that you requested and here is what I have so far. I am able to ping the G0/1 but nothing past that.
Thanks,
Router#show runBuilding configuration...Current configuration : 2319 bytes!version 15.1service timestamp...
