Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello We currently using SSG/SESM (12.3 ios & 3.2) for PWLAN with centralised architecture. So, we are planning to make some roaming peerings with other networks. The problem and the major issue is that the SESM/SSG is not supporting the WISPr attrib...
Hello alli am trying to figure out how to apply the command ssg pass-through only for a specific subnet of the incoming traffic from a Serial interface (downlink).Any examples?
Is there a 'matrix' with the number concurrent l2tp tunnels each cisco box can handle?How can i find out if a 3745 can handle about 60 concurrent tunnels with about 250 sessions ?Rgrds
Dear allWe are facing problems on implementing a BBSM routed environment. I havent understand yet if all clients and network components should be part of the Internal LAN of BBSM. If that is so, what is the use of the routers (all Access Points and c...
Hello allAs far as I know from an AS I can send periodic accounting updates to the radius with the "aaa accounting update periodic" command. Is the 'session-timeout' info for each user included in this update?Is there a way to send an authorization r...
Thanx for the tip, and as you mentioned.. i wish it could work with interface! i have dynamic ip on my dsl and i needed that...Oh well.. anyway thanx again for the info
Hello thereallthough i cant help you with your problem, i wanted to ask you which IOS you are using on your AZR. We are creating hotspots too, and i want to find the best AZR for my requirements, especially the forwarding of clients MAC address to SG...
I guess if you show us your config somebody will find the prob..btw, do you have "dialer-group 1" in youd dialer interface, in order to match the dialer with the dialer-list ?
I had no choise than to use the specific IOS (the only v.92 enabled IOS for 3640 64RAM/24Flash, at least according to TAC)My question was not how to enable the specific MIB, I know that MIBS are hard-coded into the IOS, thats why I asked about any ot...
