Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hellothere is a 6509 with SUP720 which needs to be upgrade and i'd have some questions.here is the output of show module:------------------ show module ------------------Mod Ports Card Type Model Serial No.--...
Hello!i would like to connect to a Microsoft RAS/VPN server using my laptop (winxp).my laptop is behind a cisco soho 91 router which is located at my home. i use the built in vpn client in winxp with pptp protocol. i got the 721 error every time i t...
Hello!Where can i find compatibily matrix for CCM? I could find only one link which seems to be dead. This is what i have:Cisco Callmanager System version 4.1(3)sr5dCisco Callmanager Administration version: 4.1(0.11)Cisco Callmanager Installation ID:...
Hello!Thank you. you are rigth it has helped. i just had to install BAT in "Plugins" tab.After this upgrade everything works fine with BAT.Do you also know how to upgrade CallManager Serviceability? i think it would solve the problem related to QRT t...
i want to use the outside int as a dhcp client. the problem is that the isp registers its users by mac address, and not this pix was connected to the modem by this time.
If i know well the new firmware just load to the phones if i reset them. What If i do not reset all the phones at the same time. Are they able to use the "old" firmware until i reset them?
Hello!Thank you for your reply. I have already read this document. As i mentioned i use 6.3.(5), and there is stated in this doc that i need to permit gre traffic by ACL just version 6.2 or earlier. Regarding this doc, the only thing i should do is t...
