Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have since tried to access downloads for Cisco ios images..Unfortunately I am required to find partner who sold me the device, an the worst thing is, I can't even use the device Serial number yet it is genuinely a Cisco device...How else can I gain...
I uploaded a wrong cisco aircap3720I-e-k9 access point ios instead of an autonomous ios image. Can I restore the former image?. If so how?. I have configured a tftp server to upload an image from an identical autonomous access point. Would this compl...
I have tried this configuration above on CISCo packet tracer
I configured all interfaces of all switches
- Trunks for all switches
-Access ports for all switches
I configured VLANS for all switches
-only two VLANS
-I associated the VLANS with switch...
I have two switches(Catalyst 2960). My network is flat. Do i have to configure native vlan on my trunk?.. if i leave the switches just the way they are, would they be affected the moment i plug them into the network?.....
Can I still get to view if the old image is still present?. If still present, kindly send me syntax on how. Because right now I will be dealing with a different IOS whose dynamics i don't know.
I too have this problem. First I am seeking to upgrade the IOS to a higher version. Or still retain the same version but replace the one that gives this error..If this is a hardware problem, I wonder how all the ports just died by themselves and not ...
Thank you Julio,
I have configured the switch connected to the router with a trunk interface
I have also issued PCs with IP addresses and default gateway as well
Ping still fails.
