Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!We had a broken disk on our cisco ise server which is setup using Raid 10.Went out with a new disk same size and everything but different brand, Seage instead of Thosiba BUT everything else is indentical.The disk shows up fine in CIMC, but says Un...
HiI'm trying to set up a command set in Cisco ACS 5.3, I can't get i to work no mather who I try What I'm trying to accomplish is that some users, say Bob can run every priv. level 1 command + show run, or just to specify which commands Bob will be a...
Thanks for reading!This is probably a dump question so bear with me...I have set up a VPN connection with a Cisco ASA 5505 fronting internet, with the customers environment behind it (on the same subnet), When connected ot the VPN I can reach the in...
HiWe have ACS v3.2 in our network, I have created a new user and added it to a group, is there a way in that group to specify which network routers / switches the user is able to telnet into, with a some sort of ACL or something? I have read somethin...
I'm having some trouble with getting cisco vpn traffic to flow from a remote site that's using NAT to my home Cisco VPN connection, the connection is established, but I can't do anything with my VPN connection, ping, and reach my home network is not ...
Read someone else post and it says I must get into bios and set the disk to online state?Will look more into this, thanks everyone for their help and taking their time!! If someone has any additional tips I'll be grateful!! but will read some more in...
ok, so I need to enable my new drive somehow to the Raid?I guess we have the below command on now then:This example set the physical drive status auto config mode to unconfigured-good.Server# scope chassis
Server /chassis # scope storageadapter
Serve...
