Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently, we have a router with VWIC-MFT-T1. Can this interface supports E1 local loop handoff from local provider given that the speed we subscribed is sub-T1/T1 rate (1.5M or less) from the local provider?Thanks.
Hi,Does anyone know whether we can run MLPPP for E1/T1 ports located in different adapters in 72xx routers?I tried to search the CCO but cannot find anytime on this. The only information I got is this can not be done for 75xx routers. http://www.cisc...
Can we create a IPSec tunnel over dot1q logical interface? I have managed to create IPSec tunnel on a FastEthernet interface, but when I moved it to a logical dot1q interface, the IPSec tunnel breaks.
I have two locations connected together using PA-T3+ cards with subscription of clear channel DS3 line.There are three types of framing available for PA-T3+ adapter - C-Bit, M13 & Bypass. Given that if we are using the line for point to point IP data...
I have got CNS Netflow Collection Engine to run on a RedHat Enterprise OS.Access to Collection Engine Web-based user interface was successful with netflow able to generate common reports like top talker.However, when I click on the "graph" icon, it r...
Hi attrgautam & sunilc,You guys are right.I went back cleared all configuration and started everything from scratch.The IPSec works on a logical dot1q interface without the need to apply the crypto map on the related phyiscal interface. I tried them ...
Thanks for the tip. I missed out applying the crypto map on the physical interface.One more question :- The initial objective of trunking the FE interface was to create different crypto map for each logical interface.If we need to apply crypto map to...
With 2 Sup engines, we can use route processor redundancy (RPR) and stateful switchover (SSO) to shortening the switchover time of 30 seconds or longer in RPR mode & subseconds in SSO mode if the active supervisor engine fails or if a manual switchov...
Thanks for the update. The error was the compat-libstdc++ RPM (which was a pre-req) was not installed on the system.Upon installing the RPM plus running "xvncserver" command instead of the "xvnc", the system is now graphing the output correctly.
