Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I noticed this afternoon that my Cisco SG550XG switch's CPU is running at 100%. This switch has been in use for 2 years and I have not seen this behavior before. No topology or config changes for months. Does anyone know if its possible to pinpoi...
Hi all,I was busy preparing previously unused ports on the my SG550XG when I noticed that one of the ports (te1/0/10) contains some macro config. I don't use macros and I also don't use voice on this switch. I tried to remove config but the below is ...
Hi,
I have a few IPSec tunnels between my Cisco router and my Amazon AWS VPCs (using the AWS VPC VPN functionality). I have always just downloaded the suggested configuration from the AWS VPN for Cisco and modified it for my router. I am no Cisco exp...
Hi, I am having difficulty implementing what should be an easy task. I have a single ESXi 6.5U1 host with 2 NICs teamed in a single vSwitch. The load balancing is set to “route based on IP hash”. As part of my troubleshooting I have also disabled bea...
Hi, I have 3 x Cisco 2960 switches connected to each other via PAgP EtherChannels. This works today. I would like to add LACP EtherChannels to one of my 2960 switches to connect my VMWare ESXi (vSphere 6.5) host’s via teamed NICs. The current EtherCh...
Hi, sadly I never found the cause of the issue. I resolved it by rebooting the switch and replacing a suspected faulty patch cable. Disabling SNMP and almost every other unused feature had no impact in my case. I will say that I will not purchase a p...
Here is the missing piece: https://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1022751 For anyone else - below the config on the switch side:Check and match the load balance algorithm on the switch with that...
