Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I have bought a few Cisco C9500 (C9500-24Y4C) that I want to be used as leafs in a VXLAN EVPN setup (Multi vendor, different spines) I'm trying to get the local VLANs in the C9500 to get encapsulated and sent across the tunnels to the nve peers...
We bought a 3560 PoE switch to replace tons of PoE-injectors but when connecting the devices our logs were flooded with Mar 11 15:09:20.725: %ILPOWER-7-DETECT: Interface Fa0/7: Power Device detected: IEEE PDMar 11 15:09:20.725: %ILPOWER-5-INVALID_IEE...
To be fair, I don't really need VTEP-to-VTEP communication. It wont be used in any gateway application at all. Just bridging.It all started with me wanting to use a local vlan just to verify connectivity and to see that it was working in my lab.But t...
Hello, thank you for your reply.MTU is set to 9216. IP MTU is default at 1500.Peers are up, and active;Interface VNI Type Peer-IP RMAC/Num_RTs eVNI state flags UP timenve1 10095 L2CP 10.111.0.4 1 10095 UP N/A 09:10:01nve1 10095 L2CP 10.111.0.6 1 1009...
Hello,I forgot to include the configuration for the nve1 interface, but it is present, and followsinterface nve1no ip addresssource-interface Loopback0host-reachability protocol bgpmember vni 10095 ingress-replicationend
I've included the relevant part of the configuration. There's also OSPF running for the loopback addresses.So what I *want* is the local VLAN95 (In the example) to be encapsulated and sent across L3 links, or rather, populate the BGP tables.vlan conf...
