Hi,I have configured the port channel for two ports in Cisco 3750 switch. While connecting the cable in that port i am getting the native VLAN mismatching error. Below i have attached the configuration and error details. Please help me on this.Error:...
Hi,I am using the NM-1CE1T1-PRI module in cisco 2821 router. In this module i want to terminate the PRI line, anyone can tel me it will support the SIP trunk protocol.Thanks,Karthik
Hi,We have Dell M6220 blade server that server is connected to cisco 3750 switch. I am trying to configure LACP in 3750 for two port which are connected to Dell M6220 server switch. The channel-group 2 mode active commande is not taking then its sho...
Hi,I have configured SPAN in cisco 3750 switch as below mentioned. but the destination port protocol is down.Please help on this.Network Diagram:switch(config)#monitor session 1 source interface gigabitethernet1/0/1switch(config)#monitor session 1 de...
Hi,I have connected the websense network agent server in destination port. I want to monitor/control all the traffic which are coming from the source port, for that the destination port(monitored) should be up and forward state. Please suggest on thi...
Hi Soroush,I have tried all the steps, still the protocol is down.Switch#show int gi1/0/11GigabitEthernet1/0/11 is up, line protocol is down (monitoring) Hardware is Gigabit Ethernet, address is 0021.1c1d.bf8b (bia 0021.1c1d.bf8b) MTU 1500 bytes,...
