Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I have an ASA5506W vith Ver 9.7.1 installed
Trying to get anyconnect up and running.
Anyconnect ver 4.3.04027-k9 made the ASA Reboot
ver 4.3.05017-k9 the same
I cant get any trafic through, But that's another problem.
I have a stack with 3 ws-C3850-48T switches.They are running 3.3.4SE firmware.Installed 12 sept this year.Yesterdag the stack suddently rebootet.To day they have just rebootet Again.Are there a more stable version ?
HiI have replaced a stack 3750 with a stack 3850 and are now having problems with extreme slow routing.The vlan connected directly to the firewall is getting full 80mbit internet, a vlan routet by the 3850 gets only 5-6 MbitThe 3850 stack is running ...
I have just replaced a stack 3750 with a stack 3850.After this i get around 6Mbit internet speed.If i connect a pc directly to the isp equipment i get 87Mbit.It was ok with the 3750 stack.There are no vlan config on the ASAWhat is the correct port co...
/32 mask does not make any sense.
I agree that the mask ideally should be the same in both ends, but they don't need to. The ASA does not use the broadcast address.
I am on firepower 6.0.1 (29) now. Timezone is correct, time is correct.
But on the Firepower reporting page I still get a warning. "time range was adjusted to align with report date" And the report "end time" is 2 hours behind.
