Hi - IPT newbie
We have CCM 4.0 and we are looking to integrate this into our PBX infrastructure. I am looking to use QSIG signalling between the MD110 and a 2651XM with the aim-30-voice and a VIC-1MFT-E1 in it. When I come to add the gateway on the CM, I add the 26xx for MGCP (as the only option). But on this page, there is no mention of the VWIC-1MFT-E1, only the NM-HDV network modules. Could I put one of these down instead for the MGCP configuration instead of the VWIC-1MFT-E1 as it is not mentioned.
One other question - as MGCP may not be an option for the VWIC card, I decided to try h323 with the 2651xm. I still wish to use qsig between the 2651xm and the md110. Once I have added the h323 gateway to the route list, it is displayed as ERICSSON GATEWAY (NON-QSIG). I have not specified any where not to use qsig, is qsig unsupported with H323?
Regards
