Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I write voice application using tcl programming on my cisco 2821 (c2800nm-advipservicesk9-mz.124-24.T8)I tried to use infotag set leg_target_carrier_id to set carrier id as it is described in the documentation but it I get an error:Unrecognized o...
I use a tcl ivr application. Sometime when I reload script after some changings it hangs in loading process. Removing the application service and renaming it doesn't help. Only the router reboot helps. There isn't any hung session with this applicati...
Could you help me understand how to match incoming pots dial-peer with voice-port?I have isdn pri trunks and I need to match evry trunk by using port on dial-peer.it's written: "Voice-port (associated with the incoming call setup request) with config...
Hi,
We have ip phones cisco 7911g. All of them work in the sip mode, they have the same provisioning server(Broadsoft) the same provisioning template. All of them have SIP11.8-5-4S firmware version.
The issue is that some of them cannot load or acc...
No, the file path is ok. The application can't be loaded no matter what I use a loading way( service or call application voice load).Now I cannot load any my application service. I feel like this issue is related to call application interface. Every...
debug voip app writes only//-1//SCRI:/ScriptList_ScriptLoad: Attempting to Load Script: nodes_ivrThe script is without any error, because I run it succsessfully on an other router. I tried to run this script from tftp but I cannot see any request fro...
I wanted to prevent loops. If some troubles happened in call routing from pbx side I wanted to khow from what trunk a call came no to send it back to the same trunk.
