Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an AS5400 with 8E1.When I'm trying to make a call from an E1 and exit from another E1, it works.But when I use a softphone or another gateway, the call goes unconnected and I have on my traces this line :- ISDN Se7/7:15 SC Q931: TX -> DISCO...
Good Day,We have two links with two different backbones to Internet and we want to load-balance the traffic between these two links.We can't use BGP to do that, so we are using CEF.It seems that the CEF doesn't load-balance correctly !What's going wr...
Hi,I'm using Easy ACS 2.4 to authenticate users of PPP sessions on a non-Cisco RAS.I want to fix a maximum session time to the users using Easy ACS (specific for each user).Can it be done with it ?Thanks in advance.Fethi
Hi,I'm using a modem satellite with a VSAT in simplex mode on a 2Mbps serial port on a 3640.I see on the interface a lot of input errors but no output errors, I think it's due to the way the port is used with the satellite modem, in simplex mode : th...
Hi,We have two E1 links with two different Backbones.I'm using EIGRP to load-balance ip traffic between the two links without using updates from the neighbors. So, I think, that EIGRP will only load-balance traffic using bandwidth and not metrics !I'...
I'm not using a voip dialpeer as the calls are terminated to this gateway. I need only PSTN dial-peers.I tried to add the progess-ind to the PSTN dial-peers but nothing changed.
Hi Teodor,First of all, thank you for your answer.I made a debug and here what I've found : after a call proceeding message, I should have an alerting, but there is no alerting received. So, the switch doesn't send an alerting message and the timer t...
Hi,I had the same problem before and here what I've done to solve it :- I've added this line on the voice-port config :bearer-cap 3100Hz- Also, on the interface serial this line :isdn outgoing-voice info-transfer-capability 3.1kHz-audioHope this will...
