Friends help with solving the problem!There are two c6880X-LEs and they work as a VSS pair. Scheme is below – vss.pngCisco IOS Software, c6880x Software (c6880x-ADVENTERPRISEK9-M), Version 15.5(1)SY4, RELEASE SOFTWARE (fc4)Technical Support: http://...
Hello everyone! The problem:We have about 1500 access switches with managment vlan.Network scheme is attached below.ARP aging time is not reset to zero with existing traffic in management vlans. We have OpenNMS which pings hosts every minute + takes ...
Hello.
Network scheme is attached below.
Almost 3 months ago we've built VSS pair on 6880-X for VLAN termination (hereafter referred to as "Core").
Cisco IOS Software, c6880x Software (c6880x-ADVENTERPRISEK9-M), Version 15.2(1)SY4, RELEASE SO...
Hello.
What I would like to have:
Border is used exclusively for IPv4 routing Two peers with BGP Full View Ports 100GB x 2; 10GB x 6; 1GB x 4 The total traffic is about 12Gbps Redundancy (VSS, HSRP, VRRP, ???)
At the moment, these...
Hello!
I have a similar theme, but I did not get an answer and here I painted everything in detail.
We have:
Cisco 7609-S - c7600rsp72043-advipservicesk9-mz.151-2.S.bin
Mod Ports Card Type Model Serial No.
...
Half a year ago, we upgraded to a new firmware c6880x-adventerprisek9-mz.SPA.155-1.SY2.bin, but today the same problem again appeared.Prior to this, the problem appeared every 3 months. Can anyone come across this problem and have solutions?Our probl...
Hi Then this problem does not apply the bug indicated in the past message. Of course, if there is support, it is better to go there.If possible, write what the problem was, thanks.
