Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am getting the following alerts for cert will expire. I am looking for a way to renew these certs but am not able to find where can I renew them. Trust certificate 'Certificate Services Endpoint Sub CA - XX1#00001' will expire in 21 days : Serve...
Hi,Not sure what I am doing wrong. Could someone please advise on the below error and how to fix.I am not able to apply any AutoQoS command on the interfaces on 9300 Stack of 8 SwitchesI am getting AutoQoS Error: policy-map(AuotQoS-4.0-Output-Policy)...
Hi –I hope someone can advise me on the below Current setup: Two N5k connected with VPC, running FCoE ,vlan 21 on Nexus A and vlan 22 Nexus B for the storage.Nexus Avlan 21fcoe vsan 21name VSAN-21activate zoneset vsan 21vlan 22fcoe vsan 22name VSAN-2...
Hi .I hope some one can help me out
kron policy-list BACKUP is not working on our few switches. I have notice after the job is supposed to occur, the kron policy-list disappears from the config
Below is the configuration which I have configure...
Hi Team
We have 2 ASA5515 in failover Active/Standby Mode
My secondary link is up but the OSPF State is EXSTART/DROTHER.I have the MTU size and is 1500
Neighbor ID Pri State Dead Time Address Interface 10.252.252.41 ...
Hi Reza, I have applied the solution as mention in the article –Still result is same. I have notice “ip cef load-sharing algorithm universal 1996022D : command on my another single 9300 switch running as distribution and access . Do I need this i...
