Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1.3(1), build 1.3(0.304), UI build 1.3(0.495 I'm unable to add port-channel interfaces, I keep getting the following message "The member can't be a seed for the port channel because it is in monitored mode" even though the port is 'managed' as is the...
hi,trying to set up unity 4.0(4)SR1 Voicemail only, to dial out to a pager service to drop DTMF digits in to send a page. we have checked CoS and all is ok on Unity and CM. but cannot get it to dial out just get the following messages in the CommServ...
hi, has anyone managed to get this CVPT working with Unity 4.0(5), I am unable to add my unity server as a new production system, CCM works fine, just wondered if anyone else had trouble getting the test connection to workmark
anyone managed to get this working? I have tried with OS version 2000 2.4(came with CRA) and I get to insrt disk 3 and it reads the disc and stops. i tried with OS version 2000 2.3 (came with CCM3.3(2) and I dont even get past disk one. is this somet...
hi,I am looking for a on screen pop-up for macintosh, where when a external call comes in to my IP phone the PC can refer to an address/contact list and display the name of the incoming caller by refering CLID to name. I have found products for win...
I have watched port status monitor, and no attempt to dial out is made, I also ran dbWalkwer with CoS check for notification devices which came back OK
