Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have a cisco firewall 5510 with running software 8.2(5). I want to know, will the config file (ie running-config) of this firewall works in the same model of ASA (ie 5510) which runs with software version 8.0(4) ?
If not is there any quick ...
Hi all,
Please let me know will the below scenario is going to work?
I have three unmanged switch and one cisco layer 3 switch. Please see attached diagram. If I connect the three unmanaged switch to the Cisco layer 3 switch and each connected port ...
Hi Experts,
We have a small network having 6 to 10 users and single VLAN. All were using 3Cx soft phone in their machines. Users are complaining about the voice quality so we have upgraded our bandwidth and enabled QOS in the router. But still users...
Hi Experts,I have two ISPs in my office and a layer 3 switch. Two vlans are configured in this switch. My web server is one these VLANs(only one NIC). Both ISPs are active and connected to this layer 3 switch. I want a to setup my network like, if a ...
Hi Experts,Please help me on this, I have upgraded my cisco asa from 8.2 to 9.1 version. I know that cisco made huge changes in NAT configuration. The firewall 8.2 is configured with lots static PAT and dynamic PAT lines. Now I am going to convert t...
Hi Marvin,
I am sorry there is a mistake . Actually I need to transfer the config from 8.2(5) to 8.0. So it is from a newer version to old version. I had mentioned it as in reverse in the title of discussion, now changed that. Sorry for that
In that ...
Hi Marvin,
Thank you for your valuable reply. I will check the licence version of the model and let u know.
One thing I know is the current active ASA (8.2.5) having asa825-k8.bin the other one (8.0.0) is ASA5510-SEC-BUN-K9.
If the restoration of...
Thank you for your valuable response Joseph.
I heard that the unmanageble switch can only handle Vlan 1 traffic, It will discard all other Vlan traffic. Is it true?
Ejaz
Thank you Milan for the response. I think 3CX application can tag the traffic, I saw an article from their technical blogs. I wll try that and let u knw the result.
