Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way within ACS to restrict a user to a specific VPN group. I know that if authenticated the user locally on the ASA / PIX (ver 7) you can do this with a user attribute.What I am trying to achieve here is to stop a user jumping into a diffe...
Hi all, I am battling with a RAS issue here. We have a PRI with 30 digital modems in a cisco 3620 chassis. This is used for a business application that does a RAW telnet dialup and the config automatically telnets to a server on a given port number. ...
Hi, the vpn wizard in PDM is very accurate and does work. The stpes you are basically afte rhere are below:1. Enable ISAKMP on the outside interface2. COnfigure IKE phase 1 policies - keys3. configure crypto maps and protected networks.4. Extended au...
I have seen the same problem..Ensure that the follwoing is configured on your system.1. isakmp nat-traversal.Also ensure that UDP 4500 is open as well. The VPN client when passing through a NAT device here requires this port open as well as UDP 500 a...
I had a similar issue here on an ACS 1111 appliance I upgraded to ver 4.0 from 3.2.3 Eventually a vicious power down resolved this. In your case - have you checked that the services are configured to start automatically and that the user account tied...
