Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi TeamGetting STP loop while configuring interface failover based from bigip 1600 ltm to cisco 2960 .. need configuration link or solution for the same.RegardsSudharsan.R+91 822 008 8865
Hi AllI am having issue while connect the cisco 2960G and nexus 5000, i have attached the network setup. so kinldy check and update how i can proceed further.RegardsSudharsan.R91+8220088865
TeamFrom ASA 5520 we tested the interface failover it not working even the interface are getting monitor .primary is active. Manually we shut the outside interface of the primary device configuration is getting reflecting in secondary as outside inte...
please see the output of the device and reply still we face the same issue when we shut the bluecoat outer interface failover not happening.RegardsSudharsan.R
hi varun here is the outputxxxxx-asa-01/pri/act# sh failoverFailover OnFailover unit PrimaryFailover LAN Interface: xover GigabitEthernet0/3 (up)Unit Poll frequency 1 seconds, holdtime 3 secondsInterface Poll frequency 3 seconds, holdtime 15 secondsI...
