Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to get a better understanding of how to read this traceroute because there is nothing blocking icmp on the test network I have setup. I am also not sure why there are multiple entries for hop 4. Shouldn't there only be a single hop? R1#tr...
Hello, I am able to get LDAP Authentication working for the VPN, but when I go to test a user that is not defined in the VPN group within AD, they are still able to authenticate and are granted access to the VPN. I am at a loss as to what the actual ...
Hello,I am wondering if it is possible to provide equal cost load balancing between two ISPs via EIGRP/OSPF? I have read some things online and it states that you need to use a router/BGP setup, but why would you not be able to perform equal cost loa...
I am in the middle of editing a few long ACLs that were created before my time. What I noticed is that when they were orginially created each line was created in intervals of 1. I know that I can copy the ACL out modify each line to be in intervals o...
Jatin, I have made the changes that you have mentioned, but now I am not able to authenticate with either account but they are showing both as successful when looking at the debug logs of ldap. If I look at the logs after beign authenticated they ...
Jatin, I have setup the noaccess policy and made it the default policy under the tunnel-group but both users are still able to authenticate against the LDAP server. I have posted the relevate configurations that I have for the LDAP configuration. acc...
Thank you for the quick response, and it makes sense about the security/policies of the ISP not allowing this type of connection. I am basically trying to achieve a scenario where an ASA can load-balance between two ISPs for basic Internet access, an...
I know how the line command works, but I am looking at how to add an entry in between two exisiting rules who's line entries are 1 and 2. There is no gap in between 1 and 2. Is there a way to insert a line between lines 1 and 2? Currently the configu...
