Eugen Bitca
Level 1
Level 1
Member since ‎07-15-2010
‎10-13-2021

User Statistics

  • 63 Posts
  • 0 Solutions
  • 57 Helpful votes Given
  • 45 Helpful votes Received
Recent Badges
40 Discussion Posts
40 Helpful Vote
40 Replies
5 Discussion Posts
5 Helpful Vote
50 Discussion Posts
30 Replies
30 Helpful Vote
30 Discussion Posts
60 Discussion Posts

User Activity

Hi, We have the following ISE deployment with maximum number of session 5000:Node 1 - Running Admin(Primary) + MnT (Secondary) + PSN [CPU 14, RAM 24GB, Disk 600GB]Node 2 - Running Admin(Secondary) + MnT (Primary) + PSN [CPU 14, RAM 24GB, Disk 600GB]N...
Hello, Cisco Phone is trying to atuhenticate on data vlan even port is configured with voice vlan.Only Radius and Device Sensor are used.PC and Phone are authenticated using MAB.Access Device: WS-C2960S-F24PS-L()(15.2(2)E9)!Port-Config:interface Fast...
Hello,   Cluster Transparent Mode (2 units), only 1-2 flows to the same destination host are successful, all others fail. If I remove a unit from cluster (anyone), everything is OK. When I add a unit to the cluster, cluster is OK and healthy, but onl...
Hello, I have macsec (manual mode) between 4500-x and Cat6500 Sup2. How can I verifiy if MACSEC do realy encrypt traffic, SPAN session shows traffic unencrypted.   Configuration on both sides: interface GigabitEthernet1/1 switchport mode trunk switch...
Hello, A typical Data Center ASA cluster with vPC and VSS(file attached) All interfaces and port-channels are up, vPC, VSS, Cluster all OK. 1. From Core-S1 Vlan 200 I can reach Vlan 200 on Servers LAN2. From Core-S1 Vlan 200 I can reach ip 10.44.12...
Community Statistics
Member Since ‎07-15-2010 05:08 AM
Date Last Visited ‎10-13-2021 12:10 AM
Posts 63
Total Helpful Votes Received 45
Helpful Votes From