Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I just bought the Cisco 3702e AP and I am unable to connect to it using IE and it's IP address. I can Ping the IP and I can Telnet into it but I am not any good at using the Command Line Interface. I am trying to replace my current Cisco AP1024N ...
My company, Data911 Systems, makes and sells in-car video recording systems for public safety agencies, (police departments). The systems we sell record video using cameras both inside the cars and forward facing. At the end of the shift the cars ret...
I have two Cisco Aironet 1042 AP that are set up to use a WPA2 key, (which is 32 characters and hard to type and not easy to remember), to connect to them. I have been asked to add a "Guest " account so visitors can connect through to the internet wi...
I have two Cisco Aironet 1042 AP that are set up to use a WPA2 key, (which is 32 characters and hard to type and not easy to remember), to connect to them. I have a RADIUS Server running on a Windows 2008 server that I would like to use for authentic...
I have an access point that is pretty much unresponsive. The LEDs show Radio=Green, Ethernet=Red and Status=off. Serial cable to console port using hyperterminal shows nothing on the boot. Any help with this is much appreciated.
Can use this process to switch to autonomous mode? https://www.youtube.com/watch?v=T8T__dkg7P4 , if so, I need to find out if there is firmware available for the CAP3702E to run in the autonomous mode.
I just found this as well, apparently the firmw...
Thanks, the link does not address the 3702E AP, I need to be able to operate this AP in Autonomous mode, it is currently looking to find a "CAPWAP" server so I think it is running as LWAPP?
Cisco Tech Support determined that the unit failed since it wouldn't come up in Hyperterminal on the console port, not much you can do if you cannot reset it.. They are shipping a replacement tomorrow. Many thanks to George!!
When I tried that, nothing came up, no leds are lit, when I disconnect the power again and plug it back in, it takes two or three seconds and then the ethernet go red and the radio goes green.
