Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 802.11r enabled for fast roaming, but we are still getting MS Teams Dropouts when roaming occurs.As we have Client balancing enabled, this is causing a lot of roaming to balance load(active load balancing).We are planning to turn off Client b...
Cannot access console baud rate has been changed by customer and I have tried all the standard ones 1200,2400 ect, have tried the J7 baud jumper on the mother board....?
When I use the recomended procedure in the provisioning documentationprofile.xml<flat-profile><GPP_A> 123456</GPP_A></flat-profile>openssl enc –e –aes-256-cbc –k SecretPhrase1234 –in profile.xml –out profile.cfgand I and add the relevant key to my pr...
The only indication we have is that there is a roam event in the logs and teams meeting takes a hit at that time. I have turned off client balancing and it seems to have stabilised some what, although one still had a roaming issue with a surface to...
MR56Current version: MR 29.5.1Encryption802.1X with custom RADIUSSign-on methodNoneBandwidth limitunlimitedClient IP assignmentLocal LANClients blocked from using LANnoWired clients are part of Wi-Fi networknoVLAN tag 170VPNDisabledSplash page Splash...
Hi Troy, The most usual case for mac flapping in Meraki is wireless devices jumping between access points. But if the mac is an ethernet mac then the last time I had this was when the customer inadvertently connected the vlans together.
