Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Having issues with EEM as I need to execute commands to help troubleshoot High CPU.My config:event manager directory user policy "disk0:/"event manager applet CPU_Over_80%event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.10 get-type next entry-op ge ...
I have the CSM11503 setup in a DMZ. HTTP is working fine to the servers which are in a different subnet. However I cannot get the SSL to work to those same servers. Is there a trick to get it working? What am I overlooking?Thanks
I would suggest adding a PIM priority command on the active interface on the HSRP group. This will keep your path alignment.
Sets the designated router (DR) priority that is advertised in PIM hello messages on this interface. On a multi-access netw...
Hi James,We had the same issue with almost identical IOS versions. We logged a TAC but not answer as yet! Bootvar was indicating 0x2102. The logs had a tftp to 255.255.255.255 looking for a running on reload. However when we copied the start-up con...
Hi Joseph, You are correct. After runniing the commands in debug, authorisation fails Below is the auth configs:aaa authorization exec tacacs-author group tacacs+ localaaa authorization commands 0 tacacs-author group tacacs+ localaaa authorization ...
You can use Dense but not recommended. But you can use both sparse-mode and sparse-dense-mode.Remember to use MSDP to exchange between AS also bearing in mind that reachability is required if peering via loopback and best practise to specify connect-...
