Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,I have a task to research, design, and implement NAC (802.1X) for wired network, and I wanted to find out if the servers in the data center also need to be configured for NAC authentication. We have a large compute/storage/virtualization dat...
Hello Friends,I have been chasing the following issue and can't seem to figure out what is going on.I have ISE appliance running 2.7. I have applied the latest patch as well.TACACS has been configured for device management.I have multiple IOS 93k Swi...
Hello Everyone,I have SMC 2210, FC 4210, FS 3210 in my network. Stealthwatch 7.3.1 is running on all the appliances.Quick overview of problem:I am not seeing any traffic being reported on interfaces that are being monitored on the switches (exporters...
Hello,I am attempting to configure my ISR4431 with T1 cards to perform drop and insert. Basically its not working, meaning the channels being inserted are not being seen on the other side.I want to take a 1 channel out (Raw data) of one T1 (Channel 2...
Hello everyone,I can't seem to figure out the logic behind the policy set to authenticate and authorize my users based on the privilege and device type. Sorry for the lengthy description.I have a couple of ISE 3615 appliances, running version 2.6. On...
Thank you Rob for the quick reply. We are also being tasked with deploying of Zero-Trust infrastrcuture, and I was curious if that needed to be applied on the VMs as well. I have long ways to go to fully understand all the components. Have a great da...
Thanks Richard for looking at this.I will try it this afternoon and see if I can get the debug output. I did look at the log on the switch, and the switch clearly indicates that I have successfully logged in. There is no indication at all that it fai...
Adding the following two commands did the job.collect timestamp absolute firstcollect timestamp absolute last Also, this site helped tremendously to get the config per platform. https://configurenetflow.info/
hello Ben,would you mind providing me a sample of the config? I am looking into the doc you provided, but I am not sure I'm seeing what you are referring to.I do see the following and not sure if this is what you are referring to.collect timestamp ab...
The clock is being provided (simulating Service provider) via an external appliance/device. The two T1's which connect to the appliance, have no issues in regard to Bit errors/Frame loss or anything along that line.
