Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My customer have endpoints Aethra X5 and X7 and buy the Cisco Endpoint, TP TX1310 and SX20.Topology:SX20 and TX1310 registered in CUCM 8.6 and Aethra (H323) use the VCS to translate (h323 to SIP) and invoke the CUCM endpoint.Aethra (X5 and X7) cal...
Hi,I have one problem to sent EO to ISP.My scenario:CUCM 9X -->SIP TRUNK--> CUBE --> ISP SIPI need invite Early Offer to ISP, for DTMF problems, I don´t like the use CUCM fot this.I set in CUBE (early-offer forced), but if I removed pass-thru content...
Dear Experts.I have a problem with cisco ATA187 and SIP ISP, DTMF and Fax not working together.Scenario:CUCM9.1 -->ATA187 --> SIP TRUNK -->CUBE-->SIP ISP. ATA187 -> DP-G711 -> MTP SIP TRUNK uncheck -> Fax ok -> DTMF no ok.ATA187 -> DP-G729 -> MTP SI...
Dear Experts,I have configured SIP trunk to ITSP with CUCM 9.1My call flow is IP phone ---> SIP ---> CUBE (flow around) ----> SIP -----> ITSPMy problem is on some calls the dtmf does not workI collect some logs (complete logs attached).Call Ok (tele...
Hi Ajey!Do you need configure CUCM, VG and Voice Gateway for SRST working fine.Below link with "how to" and steps:https://supportforums.cisco.com/docs/DOC-24097Post your VG config.Regards.J Rosa.
Oi Rodrigo!No CUCM versão 9 o Call adminisson control usa as locations de maneira diferente das outras versões, usa LBM, eles devem ser relacionadas entre si, e as bandas entre cada site definidas, e não somente configurada a do proprio site como era...
Hi Andrew,Please, post the your translation rule incoming.Do you can use the num-exp for this, and not necessary create the translations and dial-peer matching.Ex:num-exp 2...$ 1...Is a global translation to outbound calls and first match, after this...
