HiI am using cisco packet tracer to configure the hsrp on 3560 (c3560-advipservicesk9-mz.122-37.SE1.bin)but the standby ip Command is not available on the interface , the problem in that IOS or in config
Hi i am using 2821 router with (C2800NM-IPBASE-M), Version 12.4(3i),I want to enable the BGP , but the Version of this IOS not supporting ,, advice me and how to do it
Hi Alli have 2 no of 3560G in our core, now my requirement is to establish the redunent network like for the edge 2960G using stack or some other way ...Thanks
thnk for your reply My design is such. I use Cisco 2960G's and 3560G's at my access layer. To route between the VLANs I use the 3560G's. i need to make the core of my network is a stack of 3750G's (2no's) that my servers are plugged into.also have ...