Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys,I have ran into this problem in the past but clearly I usually change one of the remote host subnet ranges to something other than main site. Now I am in a situation that I just have to configure it this way. I just need some insight before impl...
Need assistance setting up ASA to allow passive FTP connection!I can get the FTP client to connect but it does not pull the directories. I have opened 21 and range of 55536-55566. I had some trouble gettting the range opened and saved. Normally with ...
Under protocol binding rules you'll need to set up a rule to bind all traffic out wan2 or any wan you specify.So lets say local LAN is 192.168.1.x so i would say in my protocol binding rule. source address 192.168.1.1- 254 destination address 0.0.0....
quary,Not with this Access point- not sure if any of the new AP that have just been release might have this capability so you might want to check the data sheet for WAP321 WAP221. I know the SA520W (wireless router) you can set wireless access for a...
