Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2811 router that is acting as a DMVPN headend to a few remote routers and I want to add the ability to connect Windows 10 based L2TP VPNs to it. I have followed the instructions (https://community.cisco.com/t5/security-documents/l2tp-over-ip...
Can I use a SFP-H10GB-CU5M SFP+ cable in an ASR1001X to connect it to a C4500x-16?
And can I also use the same cable to connect a UCS-C UCSC-MLOM-CSC-02= (10GB NIC) to the C4500?
Thanks.
I want to set up a network per the design shown below. What I want to verify is if the 4451x with the SM-X-ES3 module will form a multi-chassis etherchannel (MEC) to the 3850 switches.
Thank you
I have two routers, a ISR4451-X and a ISR43 connected to several layer three switches (3750X). I am using 8 port NIM-ES2-8 modules to connect the routers to the switches with SVIs. The problem is that from the 4351 to device behind the switches it ca...
I am trying to configure VLAN interfaces on a 4451X and have issue. I can configure subinterfaces, but I want to configure a real VLAN interface like this:
B12_3925(config)#int vlan 11*Jan 11 21:17:20: %LINEPROTO-5-UPDOWN: Line protocol on Interface ...
For some reason the clipboard is not working in SecureCRT on my TeamViewer session so I can't paste the IP route info right now, but I just checked both routers and they are going down the ports in question.
All ports on the 3750X are "MTU 1500 byte...
Here is the output, the ports on the 4351 are shut but the output is the same when they are up.
4451-A#sh int g0/1/4GigabitEthernet0/1/4 is up, line protocol is up (connected) Hardware is NIM-ES2-8, address is 5c83.8f84.f4fc (bia 5c83.8f84.f4fc) D...
