Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello - I have a wireless environment that has 4 -1600 series aironet waps that need to be replaced. I see the 9100 catalyst series offer EWC on the access points themselves. If I replaced these 4 would I need each of the new access points to have ...
Hello - we need to replace two 3800 series switches. We are currently utilizing the embedded wireless option. We plan on running a standalone wireless controller to separate this from the new switches. I think we want the 9200 series, we need POE. It...
Hello,
I am a little unsure of the current code we have on our switch....the current firmware version we are running is 1.4.5.02 and our boot code is 1.3.5.06...is this correct? I can't seem to find a newer boot code...we are experiencing an issue o...
We have a network utilizing 2 WS3850-48P switches, stacked. Wireless users are complaining of very slow operation (latency)....right now this is set:Qos wireless-default-untrusted......would changing this to trusted improve wireless operations?
This may not be the right forum to ask, but I have asked under LAN switching and routing and have not gotten any help, so maybe posting here will help - here is what I need help with:Set up two SSID's on four autonomous 1600 series WAPs - one for emp...
Thank you for the replies - and yes, I think we need a little more dialogue. I wasn't aware the 9000 series had embedded WLAN controllers. We may want to go this route to save on the budget - although i do like the stand alone controller to distrib...
Thank you for the response Michael - that is exactly what we did is reset the switch to factory default and could not load the backup config. We had a defective switch and it has already been replaced by Cisco and we are back up and running fine -
S...
