Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Everyone, keen to see if anyone's has this drama too??
- Have four (4) CSR1000v serially connected running on VMWARE Workstation Pro 12.5, as ...
[R1] <--LAN1 --> [R2] <--LAN2 --> [R3] <--LAN3 --> [R4]
- [R1:Gi2] has a vrf bound to subinterfa...
Everyone, keen to see if anyone's has this drama too??
- Have four (4) CSR1000v serially connected running on VMWARE Workstation Pro 12.5, as ...
[R1] <--LAN1 --> [R2] <--LAN2 --> [R3] <--LAN3 --> [R4]
- [R1:Gi2] has a vrf bound to subinterface ...
Case in point, on this graphic, I can see "Cisco IronPort Web Usage Controls - Web Categorization Prefix Filters" updated successfully to version "1398770599", but what's IN this version??? Am keen to see any improvements to mitigate "CVE-2014-177...
My own RTFM
1) At http://www.cisco.com/c/en/us/td/docs/routers/csr1000/software/configuration/b_CSR1000v_Configuration_Guide/b_CSR1000v_Configuration_Guide_chapter_00.html#con_1213069
... the PCI passthrough (enic) section, there's blah around ......
This may / may not directly help.
Have labbed a C3850 with some SVIs. Obviously, without a trunk, none of them will come up.
Even with GigabitEthernet1/0/1 configured as (essentially allow all VLANs) ...
interface GigabitEthernet1/0/1 switchport m...
FWIW with Cisco TAC and DiData on similar set of circumstances for our install, it was paramount that devices discovered and/or manually added are actually interconnected. Once added successfully, we De-activated then Activated these three pollers, ...
