Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
one of my 2802i refuses to join my WLC. On console all CAPWAP config commands fail with "Capwap process not ready yet. Try after few moments."
AP00F2.8B27.AD68#show capwap client config AdminState : ADMIN_ENABLED(1)Name : AP00F2.8B27.AD68Locati...
Hi folks,we have some pairs of 6509-VSS, which partially have old (no more officially supported) 6509-Chassis.All linecards in the VSS are the same (Sup 720-10GE-3C, 67XX).We now bought some new 6509-E-Chassis and want to change the old chassis by th...
Hi folks,we use event manager and tcl-script in an simple way on catalyst65/catalyst45-platforms (gathering arp- and mac-adress-caches).But I found nothing similar in the new sup7e (using IOS-XE Version 03.01.01.SG).So, is there a way to use "event m...
Hi,we are running two 5520 ASAs in Active-Standby-Failover and since we flashed the ASA to the newestinterim firmware release 8.2(2)17, we see the following entry:%ASA-5-720012: (VPN-Secondary) Failed to update IPSec failover runtime data on the stan...
"Capwap process not ready yet. Try after few moments."With elder AP generations i would have formated the flash in ROMMON and deployed a clean image. With u-boot the documentation is ... missing / hidden in the depths of Cisco "archive download-sw "...
At least "sh version" shows Software "ap3g3". Documentation of Mobility Express say: "If AP Image Type and AP Configuration is not available in show version, it means that the AP is running CAPWAP image." As i don't see "AP Image Type" or "AP Configu...
Neither pressing MODE for less than 20 seconds nor for more than 20 seconds on boot made any difference. AP is still stuck with "Capwap process not ready..."
Hi Flavio,"clear capwap private" doesn't exist:AP00F2.8B27.AD68#clear counters Clear statistics counters datapath Clear datapath counters or drops logging clear loggingThere is a "capwap ap erase" command, but that fails due to "Capwap proces...
Hi Jai,the problem has been a bug in the code that has been fixed some time ago.The messages were not just informational, but the information never got replicated to the standby in our setup.Best regards,Markus
