Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I got a brand new MX700 dual camera and dual display TC.7.3.1When the system start up I can see the Cisco logo on both screens.I did this manual setting as the configuration was set for a single screen. xconfig Video Monitors: Dual xconfig Vide...
I'm using TMS 14.6.0 + TPS 4.1 + Conductor 3.0.2 Is there anyway to create a conference with a random alias ? Actually I'm using the current incremental alias, but I would like to use prefix+random alias in order to secure my solution. Any suggestio...
Here is my deployment : - TMS 14.4.2- CUCM 10.5.1- Cisco Expressway-C & Cisco Expressway-E X8.2.1- Conductor XC2.3- MCU 5320 4.5 (1.45) Endpoints are registered to the CUCM. There is a SIP trunk between the CUCM and the conductor with a route pattern...
I think you should be able to choose the protocol using the CLI commands. You can choose the protocol with this command : xCommand Dial Number: "12345" Protocol: SIP
