Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am busy building/configuring a Cisco Catalyst Center (2.3.7.x). I configured the interfaces based on the configuration guide) as follows:
Enterprise InterfaceIP4 Address: X.Y.5.146IP4 Netmask: 255.255.255.248Default Gateway IP4 Address:IP4 DNS Serv...
I have a Cisco Catalyst Center in my DMZ. The Enterprise and Management Ports are all connected and allowed through my internal FW. The Cloud Port is connected to my external FW. Can I use NAT on the external FW to the Cloud Port on the Catalysts Cen...
I have a Cisco 9800-L WLC (17.3.7) and a signed third party certificate (PKCS#12) issued "godaddy". When I import the certificate it does not work (https not secured in browser) and I get and error message while importing the certificate. When I view...
I am trying to upgrade to 2.2.2.3 but I get an error message that the are packages in the process of downloading and I can only start the upgrade once those packages have been completed. The packages remain on 30% and 60% now for days!
I have tried t...
so would the recommendation then be to re-image to 2.3.7.x.... then to open a TAC to solve the issue adding routes to the network...and I won't be able to upgrade from 2.3.5.x.
I also saw there is no 2.3.7.x available for appliance only VA
Thanks for the response I did some digging and managed to find the answer....
1. I have to add the default gateway to the internet port. All unknown routes will be routed out the internet port.
2. I have to add a static route for each of the "managed...
Correct yes "internet" port. We use separate management and enterprise for internal comms to DNAC and then the internet port only for internet comms only allowing URLs and port listed in the guide.
