If I enable the Flexconnect Local Switching option on a particular WLAN, will that effect the APs in Local mode that are using the WLAN, or does it not take effect until the mode is changed? In order words, can I use the same SSID with both Local mod...

We have several remote sites that had used Cisco lightweight APs with a WLC at the central location for several years. These were running in local mode. This summer, we began transitioning to cloud-managed Meraki APs. In order to support both Cisco a...

We have several remote sites in a hub-and-spoke arrangement (central site: 9500 pair, remote sites: 4500X pair). Remote sites are connected back to the central site via the AT&T ASE on demand service.For each remote site, there is exactly one VLAN we...

We have several sites connected over ATT's ASE on demand switched metro ethernet service. We use EIGRP as our routing protocol, since we're an all Cisco environment. Since we suspect multicast might be hitting a rate limit, and our EIGRP sessions kee...

We are running several remote sites connecting back to a central site using EIGRP as the routing protocol over AT&T's ASE on demand switched ethernet service. It's been mostly fine, but occasionally for 25 or 30 minutes we get a lot of flapping that ...