Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I see "unknown protocol drops" on an interface of a 2960 switch and have a question.The "unknown protocol drops" do not seem to clear when I clear counters on the interface. Does anyone know how to clear them?
I have two 2950 LAN switches (dinosaurs) that am trying to connect via a trunk (Fa0/24 to Fa0/24). The configuration on both sides is as follows.interface FastEthernet0/24 description Trunk to Madison-Ultra-2950-3, Fa0/24 switchport trunk...
I am trying to configure dynamic PAT on a Cisco ASA 5510 using an object-group and having difficulty.How can I use an object-group, which includes five subnets, as a source for NATing to a dynamic PAT address?
Hello,While attempting to load a new IOS (cat4500-entservicesk9-mz.150-2.SG2) onto a 4948. I put new IOS on the 4948, deleted the old IOS, and reloaded it; ensuring that IOS was to be loaded from flash. That is went I noticed the UNHANDLED EXCEPTION ...
Madison-Ultra-2950-3#sh run int fa 0/24Building configuration...Current configuration : 160 bytes!interface FastEthernet0/24 description Trunk link to Madison-Ultra-2950-4, Fa0/24 switchport trunk allowed vlan 1,128,1002-1005 switchport mode trunk---...
I hadn't thought about the cross-over cable. I will try one.Madison-Ultra-2950-3#sh run int fa 0/24Building configuration...Current configuration : 160 bytes!interface FastEthernet0/24 description Trunk link to Madison-Ultra-2950-4, Fa0/24 switchport...
Here my attempt to use boot bootflash: command.rommon 5 >boot bootflash:cat4500-entservicesk9-mz.150-2.SG2.binRommon reg: 0x00004180############k2diags version 5.7prod: WS-C4948-10GE part: 73-9344-09 serial: FOX112905U3Power-on-self-test for Module...
.png "Arumugam Muthaiah"){kind=avatar}
