Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi timstumbo,
As a general rule, I avoid using interface ACLs for protecting network equipment. On some platforms or in environments with a lot of traffic, using an interface ACL can negatively impact network throughput since every packet that needs ...
Hi Colin,
You need to enable BFD under the routing process configuration, if it's supported for the protocol.
Try:
router eigrp 250 bfd all-interfaces
or
router eigrp 250 bfd interface GigabitEthernet1/8/44.80 bfd interface GigabitEthernet1/8/44.81
...
Hi Dale,
I'm assuming that the 2960-XR box is running IP-Lite feature set and is the default gateway for the VLANs.
First of all, this might be a bug. Which IOS version are you running on the switch?
How many clients are we talking about?
How is the...
Hi Bilal Saleem,
Both the Catalysts Switches will be connected to the Core Routers with using Point-to-Point 10 Gig link (uplinks are not multi-chassis but two routers connecting with each Catalyst of VSS), an IGP will be configured on these links w...
